Cisco Firepower 2100 Getting Started Manual page 102
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (178 pages)
Table of Contents
Advertisement
Troubleshoot Management Connectivity on a Data Interface
> show network
===============[ System Information ]===============
Hostname
DNS Servers
Management port
IPv4 Default route
Gateway
IPv6 Default route
Gateway
======================[ br1 ]=======================
State
Link
Channels
Mode
MDI/MDIX
MTU
MAC Address
----------------------[ IPv4 ]----------------------
Configuration
Address
Netmask
Gateway
----------------------[ IPv6 ]----------------------
Configuration
===============[ Proxy Information ]================
State
Authentication
======[ System Information - Data Interfaces ]======
DNS Servers
Interfaces
===============[ GigabitEthernet1/1 ]===============
State
Link
Name
MTU
MAC Address
----------------------[ IPv4 ]----------------------
Configuration
Address
Netmask
Gateway
----------------------[ IPv6 ]----------------------
Configuration
Check that the FTD registered with the FMC
At the FTD CLI, check that the FMC registration was completed. Note that this command will not show
the current status of the management connection.
show managers
> show managers
Type
Host
Registration
>
Cisco Firepower 2100 Getting Started Guide
100
Firepower Threat Defense Deployment with a Remote FMC
: 5516X-4
: 208.67.220.220,208.67.222.222
: 8305
: data-interfaces
: data-interfaces
: Enabled
: Up
: Management & Events
: Non-Autonegotiation
: Auto/MDIX
: 1500
: 28:6F:7F:D3:CB:8D
: Manual
: 10.99.10.4
: 255.255.255.0
: 10.99.10.1
: Disabled
: Disabled
: Disabled
:
: GigabitEthernet1/1
: Enabled
: Up
: outside
: 1500
: 28:6F:7F:D3:CB:8F
: Manual
: 10.89.5.29
: 255.255.255.192
: 10.89.5.1
: Disabled
: Manager
: 10.89.5.35
: Completed
Advertisement
Chapters
Table of Contents
