(Optional) Change Thefxosandasamanagement Ipaddresses Or Gateway - Cisco Firepower 2100 Getting Started Manual
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Getting started manual (104 pages) ,
- Getting started manual (178 pages)
Table of Contents
Advertisement
ASA Deployment with ASDM
Mode is currently set to platform
Step 6
(Optional) Set the mode back to Appliance mode.
fxos mode appliance
write memory
reload
After you set the mode, you need to save the configuration and reload the device. Prior to reloading, you can
set the mode back to the original value without any disruption.
Example:
ciscoasa(config)# fxos mode appliance
Mode set to appliance mode
WARNING: This command will take effect after the running-config is saved and the system has
been rebooted. Command accepted.
ciscoasa(config)# write memory
Building configuration...
Cryptochecksum: c0532471 648dc7c2 4f2b4175 1f162684
23736 bytes copied in 1.520 secs (23736 bytes/sec)
[OK]
ciscoasa(config)# reload
Proceed with reload? [confirm]
(Optional) Change theFXOSandASAManagement IPAddresses
or Gateway
You can change the FXOS management IP address on the Firepower 2100 chassis from the FXOS CLI. The
default address is 192.168.45.45. You can also change the default gateway for FXOS management traffic.
The default gateway is set to 0.0.0.0, which sends FXOS traffic over the backplane to be routed through the
ASA data interfaces. If you want to route traffic to a router on the Management 1/1 network instead, then you
can change the gateway IP address. You must also change the access list for management connections to
match your new network. If you change the gateway from the default 0.0.0.0 (the ASA data interfaces), then
you will not be able to access FXOS on a data interface nor will FXOS be able to initiate traffic on a data
interface (see
Typically, the FXOS Management 1/1 IP address will be on the same network as the ASA Management 1/1
IP address, so this procedure also shows how to change the ASA IP address on the ASA.
Before you begin
• After you change the FXOS management IP address, you need to reestablish any Firepower Chassis
• Because the DHCP server is enabled by default on Management 1/1, you must disable DHCP before you
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
Manager and SSH connections using the new address.
change the management IP address.
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway
Cisco Firepower 2100 Getting Started Guide
213).
197
Advertisement
Chapters
Table of Contents
