Reel Motor (Barnes) - Toro Reelmaster 6500-D Service Manual
Hide thumbs
Also See for Reelmaster 6500-D:
- Service manual (366 pages) ,
- Quick service reference (258 pages) ,
- Operator's manual (48 pages)
Table of Contents
Advertisement
Reel Motor (Barnes)
1
3
2
Use seal protector tool
TOR4072 when inserting
shaft through seal.
NOTE: Seal protector tool is
part of TOR4070 Cutting Unit
Tool Kit shown in Chapter 7 -
Cutting Units.
1. Retaining Ring
2. Shaft Seal
3. Flange
4. E-Seal
5. O-ring
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect hydraulic lines. Put caps or plugs on fit-
tings and hoses to prevent contamination. Tag hydraulic
lines for proper reassembly.
3. Loosen motor mounting nuts (Fig. 41).
4. Rotate motor clockwise so motor flanges clear studs
and pull motor out.
Installation
1. Place motor into position on mounting studs. Rotate
motor counterclockwise so motor flanges lock to studs.
2. Tighten motor mounting nuts.
3. Remove caps or plugs from fittings and hoses. Con-
nect hydraulic lines lines to the motor.
Hydraulic System
4
12
5
6
5
Figure 40
6. Dowel Pin
7. Valve Block
8. Adjusting Valve
9. Rear Bearing Block
Page 4 - 68
11
10
9
13
4
1
1. Reel motor
Rev. E
40 to 45 ft- -lb
(54 to 61 N- -m)
7
8
10. Drive Gear
11. Gear Housing
12. Front Bearing Block
13. Idler Gear
2
Figure 41
2. Motor mounting nut
Reelmaster 6500-D/6700-D
- Quick Links:
- Table of Contents
- Specifications
- Mow and Backlap
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
