Table of Contents
Advertisement
Electrical connection
6.4 Connecting cables
6.3
Terminal designations
According to IEC / EN 60034-8, the following basic definitions apply to the terminal
designations on DC motors:
Table 6-1
B
x
The terminal diagram pasted into the terminal box shows only the conditions required for
connection to the line power supply, without detailed representation of inner connections or
winding components.
6.4
Connecting cables
The power cables are connected in the terminal box. Supplementary connections for auxiliary
circuits with terminal strips for cable cross-sections of up to 2.5 mm
post insulators or Terminal Boards (depending on construction type) are provided for
connecting the excitation circuit.
● Terminal boxes can also be rotated by 90° in each case depending on the connecting
● Connect the cables in such a way as to ensure a permanent and reliable electrical
● Make sure the protective conductor connection is secure.
● Comply with the rating plate data and the terminal diagram in the terminal box when making
54
Terminal designations in example B1
1
Designation
Code letter for winding parts (A, B, C, D, E, F)
x
Identification number showing winding start (1), end (2), or tapping if there is more than
one connection per winding
direction. Please ensure that winding feeder cables are relaid correctly. In this case, the
insulator plate does not need to be repositioned. Under difficult conditions, e.g. with large
cross sections or a large number of cables, repositioning a terminal box may only be
possible with restrictions or special adaptation steps may be necessary.
connection. Depending on their design, the connecting parts may be suitable for connection
with or without cable lugs. Use the matching cable end pieces.
the electrical connections.
are provided. Terminal
2
SIMOTICS DC 1GG6
Operating Instructions 02/2016
Hide quick links:
Advertisement
Table of Contents
