Toro Z597-D Z Master Setup Instructions page 4

With a 62 or 72 rear discharge mower

Hide thumbs Also See for Z597-D Z Master:

Figure 7

3. Lightly oil the ends of the center roll bar

section.

4. Loosely install the center roll bar section using

2 bolts (1/2 x 3-1/4 inch) and 2 ﬂange nuts

(1/2 inch).

Note: Make sure the bolts are installed from

the outside of the roll bar.

Note: Make sure the lanyard tab is installed

as show and points forward.

Figure 8

5. Raise the roll bar into the upright position and

secure it with the pins and hairpin cotter pins

fastened to the lanyards

Figure 9

6. Torque all lower fasteners, attached to the

machine frame, to 30 ft-lb.

7. Tighten the center roll bar bolts (1/2 x 3-1/4

inch) so it rotates freely with some resistance.

Note: No more than one thread should be

exposed outside the nut.

Table of Contents