Table of Contents
Advertisement
4.
Save the view mode settings by clicking the Save button in the
Allow View Mode Settings section. Alternatively, clear the
settings by clicking the Reset button.
7.8.2. Changing the Administrator username and password
The CHANGE USERNAME AND PASSWORD section contains controls to
change the Administrator's user name and password for the Fluidmesh unit.
To change the Administrator's user name and password for the unit, do
the following steps:
1.
Click the -remote access link under MANAGEMENT SETTINGS
in the left-hand settings menu.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
• If the Enabled option is selected for a device-configuration
setting, the setting can be modified by ordinary users.
IMPORTANT
If you are logged in to the Configurator interface with
Administrator credentials, you can enable or disable
any device-configuration setting.
If you are logged in to the Configurator interface as
an ordinary user, you will be able to view the device-
configuration settings, but cannot change the
settings.
IMPORTANT
Changing the default password to a strong password is an
extremely important step in preventing security breaches.
If you have logged into the configurator interface using default
administrator's credentials, you will see a notification banner at
the bottom of the screen
Figure 54. Default admin credentials notification banner
Click the banner to change the admin credentials. You will be
taken to the CHANGE USERNAME AND PASSWORD
section.
• The CHANGE USERNAME AND PASSWORD dialog will
be shown
(Figure 55 (page
(Figure 54 (page
126)).
127)).
Page 126 of 177
Advertisement
Table of Contents
