Table of Contents
Advertisement
To change the RADIUS settings for the Fluidmesh unit, do the following
steps:
1.
Enable and configure network time protocol (NTP) as shown in
"NTP Configuration" (page
2.
Click the -radius link under ADVANCED SETTINGS in the left-
hand settings menu.
• The RADIUS dialog will be shown
3.
Choose the RADIUS mode for the device by clicking the RADIUS
Mode drop-down and selecting one of the following options:
• Disabled: RADIUS functionality will be disabled.
• Enabled: RADIUS functionality will be enabled, and the
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
Use of this window requires extensive familiarity with the
RADIUS networking protocol. Do not change these settings
unless there is a specific need to do so.
Figure 45. Configurator GUI (RADIUS dialog)
configuration options will be shown.
112).
(Figure 45 (page
110)).
Page 110 of 177
Advertisement
Table of Contents
