hit counter script

Brother 888-M20 Operation Manual page 28

Embroidery and sewing machine
Hide thumbs Also See for 888-M20:
Table of Contents

Advertisement

Sewing
g
Set the fabric under the presser foot. Hold the fabric
and thread with your left hand, and rotate the
handwheel counterclockwise or press
position button) to set the needle in the sewing start
position.
h
Lower the presser foot lever.
i
Adjust the sewing speed with the sewing speed
controller. (when using utility stitches)
You can use this controller to adjust sewing speed
during sewing.
a
j
Press the "Start/Stop" button to start sewing. (When
the foot controller is plugged in, slowly press down on
the foot controller.)
Guide the fabric lightly by hand.
Memo
• When the foot controller is being used, you cannot start
sewing by pressing the "Start/Stop" button.
k
Press the "Start/Stop" button again to stop sewing.
(When the foot controller is plugged in, remove your
foot from the foot controller.)
l
Press
(Thread cutter button) to trim the upper and
bobbin threads.
 The needle will return to the up position
automatically.
26
(Needle
1 Fast
2 Slow
CAUTION
• Do not press
(Thread cutter button) after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
• Do not press
(Thread cutter button) when
there is no fabric set in the machine. The
thread may tangle, possibly resulting in
damage.
Note
• When cutting thread such as nylon monofilament
thread, or other decorative threads, use the thread
cutter on the left side of the machine.
When the needle has stopped moving, raise the presser
m
foot lever and remove the fabric.
n
Check the sewing finish. If necessary, adjust the thread
tension. (page 29)
■ Using the foot controller
You can also use the foot controller to start and stop
sewing.
Memo
• When the foot controller is connected, you cannot use
the "Start/Stop" button.
• Bobbin winding can be started and stopped with the
foot controller.
• The foot controller cannot be used when embroidering.
a
Turn off the machine.
b
Insert the foot controller plug into the foot controller
jack on the machine.
1
c
Turn on the machine.
1 Foot controller jack

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents