Table of Contents
Advertisement
Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit
c) Secure the front-mount bracket and the back-mount bracket to the chassis using four M4 screws and tighten each
screw to 12 in-lb (1.36 N·m) of torque.
d) Repeat Step 1 for the other front rack-mount bracket and the other back-mount bracket on the other side of the switch
and be sure to position that bracket the same distance from the front of the switch.
Note
Depending on the chassis depth, the back rack-mount bracket may not fit. In that case the back rack-mount
bracket is not needed.
Step 2
If you are not installing the chassis into a grounded rack, you must attach a customer-supplied grounding wire to the
chassis as explained in the
rack, you can skip this step.
Step 3
Install the slider rails on the rack or cabinet as follows:
a) Determine which two posts of the rack or cabinet you should use for the slider rails. Of the four vertical posts in the
rack or cabinet, two will be used for the front mount brackets attached to the easiest accessed end of the chassis, and
the other two posts will have the slider rails.
b) Position a slider rail at the desired level on the back side of the rack and use 12-24 screws or 10-32 screws, depending
on the rack thread type, to attach the rails to the rack (see the following figure). Tighten 12-24 screws to 30 in-lb
(3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.
Cisco Nexus C9316D-GX NX-OS Mode Switch Hardware Installation Guide
16
Grounding the Chassis, on page 18
section. If you are installing the chassis into a grounded
Installing the Chassis
Advertisement
Table of Contents
