Table of Contents
Advertisement
Figure 42. Configurator GUI (MISC SETTINGS dialog)
2.
Set the device name by typing it in the Name: field.
3.
To enable CANBUS support for the unit, make sure the FM-
CANBUS plug-in is installed, then check the Enable CANBUS:
check-box.
4.
To enable PROFINET support for the unit, make sure the FM-
PROFINET plug-in is installed, then check the Enable
PROFINET: check-box.
5.
To enable QNET support for the unit, make sure the FM-QNET
plug-in is installed, then check the Enable QNET: check-box.
6.
Save the miscellaneous settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.
6.8. Management settings
6.8.1. View Mode settings
The View Mode window allows the system administrator to grant and
prohibit access to device configuration settings by category.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
It is not essential to specify the device name, but it is
strongly recommended. Failure to specify the device
name may make the unit difficult to recognize in
situations where more than one unit is being dealt
with at the same time (for example, when using
utilities such as the FMQuadro network map).
Page 91 of 138
Advertisement
Table of Contents
