Zanussi ZBA 6160 Instruction Booklet
Zanussi refrigerator instruction booklet
Hide thumbs
Also See for ZBA 6160:
- Specification (5 pages) ,
- Specifications (7 pages) ,
- Instruction booklet (12 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZBA 6160
Summary of Contents for Zanussi ZBA 6160
- Page 1 REFRIGERATOR ZBA 6160 ZBA 6230 INSTRUCTION BOOKLET 2222748-78...
-
Page 2: Important Safety Instructions
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation •... -
Page 3: Table Of Contents
At the end of the Appliance Life • When disposing of your appliance use an authorised disposal site. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. -
Page 4: Operation
Operation Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Setting the temperature The temperature inside the refrigerator is regulated by a thermostat control knob with 6 temperature positions and one «OFF»... -
Page 5: Normal Operating Sounds
For more thorough cleaning, the top door shelf and the bottle shelf can be removed by pulling them in the director of the arrows, then refitting them in position. Health and Safety Guidelines Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. -
Page 6: Defrosting
Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment... -
Page 7: Something Not Working
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom No power to appliance The light does not come on... -
Page 8: Service And Spare Parts
Customer Care Department For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk... -
Page 9: Guarantee Conditions
Standard guarantee conditions We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •... -
Page 10: Technical Specifications
The following table shows which ambient temperature is correct for each climate classification. +10°C to +32°C +18°C to +38°C ZBA 6160 _ 230-240 V / 50 Hz _ 0,41 158 l 154 l... -
Page 11: Door Reversal
Door reversal The appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove the relevant pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. -
Page 12: Electrical Connection
Electrical Connection WARNING THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. -
Page 13: Building In
Building in Dimensions of the recess ZI 9155 A Height of housing (1) Depth of housing (2) Width of housing (3) It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 50 mm D526 For appropriate venting, follow indications in the figure. - Page 14 4. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. PR266 5. Separate parts Ha, Hb, Hc, Hd figure. ca. 50 mm 90° 90° ca. 50 mm 6. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.
- Page 15 PR168 10. Place the small square on the guide again and fix it with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure, it is necessary to check if the door of the furniture closes properly.
- Page 16 © Electrolux plc 2007...