Rsp And Rp Port Connection Guidelines - Cisco ASR 9000 Series Installation Manual
Aggregation services router hardware
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Preparing for Installation
Figure 60: NEBS Bonding and Grounding Point on the Cisco ASR 9922 Router
1
To ensure a satisfactory supplemental ground connection to the router, use the following parts:
• One grounding lug, which has two holes with 0.625- to 0.75-inch (15.86- to 19.05-mm) spacing between
• Two 10-32 x 0.25-inch round-head screws and two locking washers (nickel-plated brass is ideal).
Note
The chassis ground wire connectors have a torque value of 30 in-lb.
• One grounding wire. Although we recommend at least #6 AWG multistrand copper wire, the wire diameter
Note
These parts are not available from Cisco, but they are available from commercial vendors.
RSP and RP Port Connection Guidelines
Refer to the
Aggregation Services Router Overview and Reference Guide for detailed information about the Route System
Processor (RSP) or Route Processor (RP) cards interface and port connections.
Note
The generic term RSP card refers to the RSP-440, RSP-440 Lite, RSP-880, RSP880-LT, RSP4-S, and
A99-RSP-TR/SE cards unless otherwise specified.
Caution
Ports labeled Ethernet, SYNC, CONSOLE, and AUX are safety extra-low voltage (SELV) circuits. SELV
circuits should only be connected to other SELV circuits.
them, and a wire receptacle able to accept a #6 AWG or larger, multistrand copper wire.
and length depend on your router location and site environment.
Route Switch Processor and Route Processor Cards
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
RSP and RP Port Connection Guidelines
NEBS grounding point near bottom, rear, right side
of the chassis
section in the Cisco ASR 9000 Series
47
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
