Management Lan Port Led Indicators; Management Lan Rj-45 Cabling - Cisco ASR 9000 Series Installation Manual
Aggregation services router hardware
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Management LAN Port LED Indicators
MGT LAN Port
Pin
5
6
7
8
Management LAN Port LED Indicators
The Management LAN connectors have integral LED indicators. When lit, these LEDs indicate:
• Green (LINK)—Connection is alive.
• Amber (ACT)—Connection is active.
Figure 61: RSP/RP Management LAN Port LED Indicators
Management LAN RJ-45 Cabling
When connecting the RJ-45 port to a hub, repeater, or switch, use the straight-through cable pinout as shown
in the below figure.
Note
To comply with the intrabuilding lightning surge requirements of Telecordia GR-1089-CORE, Issue II,
Revision 01, February 1999, you must use a shielded cable when connecting to the management LAN ports
on the RSP/RP card. The shielded cable is terminated by shielded connectors on both ends, with the cable
shield material tied to both connectors.
Figure 62: Straight-Through Cable Pinout to a Hub, Repeater or Switch
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
50
100Base-TX Signal
1000Base-T Signal
Unused
BI_DC–
Receive–
BI_DB–
Unused
BI_DD+
Unused
BI_DD–
Preparing for Installation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
