Installing Fan Trays; Prerequisites; Required Tools And Equipment; Steps - Cisco ASR 9000 Series Installation Manual
Aggregation services router hardware
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Installing Fan Trays
3 Power Module in the Cisco ASR 9010, 9912, 9922 Routers, on page 161
module.
Procedure
Step 1
Slide the power module into the power tray until it mates with its backplane connector.
Step 2
Secure the module:
• Version 1 power module: Pivot the power module door fully to the left until it locks to securely seat the
• Version 2 power and version 3 module: Move the handle up and tighten the screw using the 7/16 hex
Step 3
Repeat for the other DC power modules.
Caution
Installing Fan Trays
Prerequisites
Install the power modules before installing the fan trays.
Required Tools and Equipment
You need the following tool to perform this task:
• 6-inch long number 2 Phillips screwdriver, torque 10 inch-lb.
Steps
Note
If you are installing a fan tray for the Cisco ASR 9010 Router, install the lower fan tray before attaching the
accessory grill. The lower fan tray slot is located behind the accessory grill. See the
Accessories, on page 125
Note
The high-density 100G line cards or the Modular 400G line card need the version 2 fan trays.
Before installing the fan tray, first determine its location. Refer to the figure that applies to your router. See
Removing Fan Trays, on page
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
162
power module to its backplane connector.
socket and torque wrench with the torque set to 50 in-lb.
To prevent damage to the power tray backplane connector, do not use excessive force when inserting
the power module into the power tray.
74.
Installing Cards and Modules in the Chassis
for the version 2 or version 3 power
Installing Chassis
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
