Table of Contents
Advertisement
Information about RPD IPv6
Information about RPD IPv6
The CableLabs' MHAv2 standards requires CCAP Core and RPD must support both IPv4 and IPv6, which
means the Remote PHY Signaling between the CCAP Core and RPD is able to run on both IPv4 and IPv6
networks.
Note
• CCAP Core can support IPv4/IPv6 dual stack.
• RPD can support either IPv4 or IPv6 network.
• RPD does not support IPv4/IPv6 Dual Stack at the same time.
• RPD will try IPv6 connection first. When DHCPv6 failed, RPD will try DHCPv4.
• For single RPD, all the server addresses, protocols to communicate with it must be in the same IP version.
Configure RPD IPv6 Unicast Online
This section describes how to configure RPD IPv6 Unicast Online on Cisco cBR-8.
Note
To know more about the commands referenced in this module, see the
Configure Unicast IPv6
To configure Unicast IPv6, complete the following procedure:
1. Enable IPv6 unicast routing.
configure terminal
ipv6 unicast-routing
2. Configure IPv6 Address on DPIC interface.
configure terminal
interface TenGigabitEthernet
ipv6 enable
ipv6 address
Configure RPD core interface
To configure RPD core interface, complete the following procedure:
configure terminal
cable rpd
identifier
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
80
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
ipv6_address
name
rpd_mac
Cisco IOS Master Command
slot/1/port
List.
Advertisement
Table of Contents
