Table of Contents
Advertisement
Cisco Remote PHY Shelf 7200 High Availability Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Port Mapping and Redundancy
Figure 4: Default 6+2 Port Mapping
In this mode, if all SFP+ ports are active and the default port mapping is configured, then each PHY device
can receive up to 10Gbps unicast traffic or 6Gbps unicast and 4Gbps multicast traffic from the backhaul
network.
Based on bandwidth requirements, you can use any number of SFP+ ports. The mapping of ports can be
configured using CLI commands. For example, when you want to use only one SFP+ port and all PHY devices,
then you can map the ports like this.
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
47
Advertisement
Table of Contents
