Table of Contents
Advertisement
Cisco 910 Industrial Router Installation
Installing and Removing the Sensor Card
Installing and Removing the Sensor Card
This section describes the installation and removal of the sensor card.
Assembling the Sensor Card to the Carrier, page 32
Installing the Sensor Card Module into the Router, page 33
Removing the Sensor Card Module From the Router, page 33
Note:
If you have ordered a LoRa card from Cisco together with the router, the LoRa card will be preinstalled into the
router.
Assembling the Sensor Card to the Carrier
If you have ordered the sensor card from Cisco together with your chassis, the sensor card module will be preinstalled
into the router. If you use your own sensor card, you can order a sensor card carrier to assemble your sensor card into it.
To assemble your own sensor card into the sensor card carrier, follow these steps:
1.
Put the sensor card onto the plate of the sensor card carrier, as shown in
Figure 5
Assembling Sensor Card to the Carrier
1
M2 x 4 mm screws
2
Captive screws
2.
Align the two boles near the top of the sensor card with the two bores on the carrier plate.
3.
Thread an M2 screw through each bore in the sensor card and down into the corresponding bore in the sensor card
carrier plate.
1
2
3
4
Figure
3
4
Sensor card
Sensor card carrier plate
32
5.
Advertisement
Table of Contents
