Table of Contents
Advertisement
Cisco 910 Industrial Router Installation
Verifying Router Operation
IP55 enclosure and wall or pole mount kit (model number: ACC-IR910-H-M=)—IP55-certified dust-and-water
protection for outdoor usage by wall or pole mounting.
Open slot modular mount bracket (model number: ACC-IR910-W-M=)—This mount bracket is orderable strictly by
partners who builds sensor module card PCBA and need this bracket for faceplate assembly.
Verifying Router Operation
Before installing the router in its final location, power on the router, and verify that the router passes the power-on
self-test (POST).
These sections describe the steps required to connect a PC or terminal to the router console port, to power on the router,
and to observe POST results:
Connecting a PC or a Terminal to the Console Port
Verifying Router Operation
Connecting a PC or a Terminal to the Console Port
You can access the CLI by connecting the console port to your PC or workstation and accessing the router through a
terminal emulation program.
To connect a PC to the console port, use an RJ-45-to-DB-9 adapter cable. To connect a terminal to the console port,
provide an RJ-45-to-DB-25 female DTE adapter.
The PC or terminal must support VT100 terminal emulation. The terminal-emulation software—frequently, a PC
application such as HyperTerminal or Procomm Plus—makes communication between the router and your PC or terminal
possible.
Follow these steps to connect the PC or terminal to the router:
1.
Using an RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into the console port on the front panel of the
router and connect the other end to the PC or terminal port.
2.
Start the terminal-emulation program on the PC or terminal.
3.
Configure the baud rate and data format of the PC or terminal to match these console-port default characteristics:
—
115200 bits per second
—
8 data bits
—
1 stop bit
—
No parity
—
None (flow control)
After you get access to the router, you can change the port baud rate. See the Cisco 910 Industrial Router Software
Configuration Guide for instructions.
1.
Connect the power of the router. The PC or terminal displays the bootloader sequence.
2.
Press Enter to display the setup prompt.
25
Advertisement
Table of Contents
