Siemens SINUMERIK 802D sl Function Manual page 179
Turning, milling, nibbling
Hide thumbs
Also See for SINUMERIK 802D sl:
- Programming and operating manual (364 pages) ,
- Instruction manual (262 pages) ,
- Programming manual (251 pages)
Table of Contents
Advertisement
Other program name
A name is specified in MD11620 PROG_EVENT_NAME (program name of PROG_EVENT).
The following directories are searched for the user program in the specified sequence:
● /_N_CUS_DIR/ for user cycles
● /_N_CMA_DIR/ for manufacturer cycles
The first program found with the stored name is called when a configured event occurs.
The same protection mechanisms that can be activated for cycles (protection levels for
writing, reading etc.) are activated.
MD20108 PROG_EVENT_MASK is ignored during the simulation.
Request which start event
In the user program, the system variable $P_PROG_EVENT can be used to request the
event, which enabled the part program.
Event
Part program start
Table 10- 7
Sequence when starting a part program
Seque
Command
nce
1
Channel selection: Reset status
Operating mode selection: AUTO or
AUTO and overstoring or
MDA or TEACH IN
2
3
MD20112 START_MODE_MASK
4
/_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
5
6
Event
Part program end
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
NC Start
Operating Modes, Program Operation (K1)
Boundary conditions
(must be satisfied before the
command)
None
None
Initialization sequence with
evaluation
as a subroutine
None
None
10.3 Processing a part program
Comments
Select channel and mode
NCK start
Implied call of the path name as
a subroutine
Processing of the data part of the
main program
Processing of the program part of
the main program
179
- Quick Links:
- Signals from Plc to Nck
Hide quick links:
Advertisement
Table of Contents
