Installing A System Power Supply - Siemens Simatic S7-1500R System Manual
Redundant system
Hide thumbs
Also See for Simatic S7-1500R:
- Manual (45 pages) ,
- Equipment manual (43 pages) ,
- System manual (393 pages)
Table of Contents
Advertisement
Installation
4.4 Installing a system power supply
Uninstalling the load current supply
The load current supply is wired up.
To uninstall a load current supply, follow these steps:
1. Open the front cover.
2. Shut down the load current supply.
3. Turn off the supply voltage.
4. Disconnect the power cable connector, and remove the connector from the load current
supply.
5. Unscrew the fixing screw.
6. Swivel the load current supply out of the mounting rail.
Reference
Additional information can be found in the manuals for the load current supplies.
4.4
Installing a system power supply
Introduction
The system power supply has a connection to the backplane bus and supplies the
connected modules with the internal supply voltage.
Requirements
The mounting rail is installed.
Tools required
Screwdriver with 4.5 mm blade
104
S7-1500R/H redundant system
System Manual, 10/2018, A5E41814787-AA
Hide quick links:
Advertisement
Table of Contents
