Table of Contents
Advertisement
Assembling
5.3 Installing the machine
5.3
Installing the machine
Note
Service Center
For any installation work that is required, contact the Service Center (Page 113) or commission
service engineers trained by Siemens and authorized for this task.
5.3.1
Safety instructions for installation
Inappropriate fastening material
If screws of an incorrect property class have been selected or if they have been fastened to
an incorrect tightening torque, they may break or become loose. This will cause the machine
to move, which could damage the bearings. The rotor could smash into the machine enclosure
and machine parts could be flung out of place. This can result in death, serious injury or
material damage.
● Comply with the required property classes for screwed connections.
● Tighten the screwed connections to the specified tightening torques.
Incorrect alignment
If the machine has not been properly aligned, this will mean the fastening parts are subjected
to stress/distortion. Screws may become loose or break, the machine will move, machine
parts could be flung out of place. This can result in death, serious injury or material damage.
● Carefully align the machine to the driven machine.
NOTICE
Improper handling
Mounting parts such as temperature sensors or speed sensors are attached to the machine
and could be ripped off or destroyed as a result of improper handling. This could lead to
machine malfunctions, extending even to total loss of the machine.
● Where necessary, use suitable steps when performing installation work on the machine.
● Do not stand on cables or attachments during installation. Do not use attachments as
44
WARNING
WARNING
steps.
SIMOTICS DC 1GH5
Operating Instructions 02/2016
Hide quick links:
Advertisement
Table of Contents
