Table of Contents
Advertisement
Maintenance
9.1 Inspection and maintenance
Dust disturbances when working with compressed air
When cleaning with compressed air, dust, metal chips, or cleaning agents can be whirled up.
Injuries can result.
When cleaning using compressed air, make sure you use suitable extraction equipment and
wear protective equipment (safety goggles, protective suit, etc.).
NOTICE
Damage to insulation
If metal swarf enters the winding head when cleaning with compressed air, this can damage
the insulation. Clearance and creepage distances can be undershot. This may cause damage
to the machine extending to total failure.
When cleaning with compressed air, ensure there is adequate extraction.
NOTICE
Machine damage caused by foreign bodies
Foreign bodies such as dirt, tools or loose components, such as screws etc., can be left by
accident inside the machine after maintenance is performed. These can cause short circuits,
reduce the performance of the cooling system or increase noise in operation. They can also
damage the machine.
● When carrying out maintenance work, make sure that no foreign bodies are left in or on
● Securely attach all loose parts again once you have completed the maintenance
● Carefully remove any dirt.
Note
Operating conditions and characteristics can vary widely. For this reason, only general
intervals for inspection and maintenance measures can be specified here.
9.1.1
Initial inspection
● Perform the initial inspection after installing or commissioning the motor. Normally the initial
● Perform follow-up inspections after every approx. 2,000 hours of operation.
78
CAUTION
the machine.
procedures.
inspection is only necessary after approx. 500 hours of operation.
SIMOTICS DC 1GH5
Operating Instructions 02/2016
Hide quick links:
Advertisement
Table of Contents
