Configuring Static Point-To-Point Cross-Connects - Cisco CRS Configuration Manual
Ios xr virtual private network
Hide thumbs
Also See for CRS:
- Configuration manual (430 pages) ,
- User manual (304 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Implementing Point to Point Layer 2 services
Example:
RP/0/RP0/CPU0:router(config-if)# encapsulation dot1q vln1
Assigns native VLAN ID to an interface trunking 802.1Q VLAN traffic.
Step 7
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Static Point-to-Point Cross-Connects
Consider this information about cross-connects when you configure static point-to-point cross-connects:
Note
• An cross-connect is uniquely identified with the pair; the cross-connect name must be unique within
• A segment (an attachment circuit or pseudowire) is unique and can belong only to a single
• A static VC local label is globally unique and can be used in one pseudowire only.
• No more than 16,000 cross-connects can be configured per router.
Static pseudowire connections do not use LDP for signaling.
Note
Perform this task to configure static point-to-point cross-connects.
a group.
cross-connect.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring Static Point-to-Point Cross-Connects
19
Advertisement
Table of Contents
