Configuring L2Vpn Quality Of Service; Restrictions; Configuring An L2Vpn Quality Of Service Policy In Port Mode - Cisco ASR 9000 Series Configuration Manuallines
L2vpn and ethernet services configuration guide
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing Point to Point Layer 2 Services
Configuring L2VPN Quality of Service
This section describes how to configure L2VPN quality of service (QoS) in port mode and mode, VLAN
mode, Frame Relay and ATM sub-interfaces.
Restrictions
The l2transport command cannot be used with any IP address, L3, or CDP configuration.
Configuring an L2VPN Quality of Service Policy in Port Mode
This procedure describes how to configure an L2VPN QoS policy in port mode.
Note
In port mode, the interface name format does not include a subinterface number; for example,
GigabitEthernet0/1/0/1.
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2transport
4. service-policy [ input | output ] [ policy-map-name ]
5. Use the commit or end command.
6. show qos interface type interface-id service-policy [ input | output ] [ policy-map-name ]
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the configuration mode.
Step 2
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/0/0/0
Specifies the interface attachment circuit.
Step 3
l2transport
Example:
RP/0/RSP0/CPU0:router(config-if)# l2transport
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring L2VPN Quality of Service
109
Advertisement
Table of Contents
