Table of Contents
Advertisement
CYLINDER HEAD COVERS, CYLINDER HEADS
1
CHECKING THE ROCKER ARMS AND ROCKER
ARM SHAFTS
The following procedure applies to all of the rocker arms
and rocker arm shafts.
1.
Check:
• Rocker arm "1"
• Rocker arm shaft "2"
Wear/damage/cracks Replace.
2
CHECKING THE PUSH RODS
The following procedure applies to all of the push rods.
1.
Check:
• Push rod runout
Runout limit:
0.3 mm (0.0118 in)
Out of specifications Replace.
REMOVING THE CYLINDER HEADS
The following procedure applies to all of the cylinder
heads.
1.
Remove:
• Cylinder head
TIP
Set the piston at TDC (top-dead-center) on the compres-
sion stroke.
(Refer to "ADJUSTING THE VALVE CLEARANCE" on
page 2-9)
CHECKING THE CYLINDER HEADS
The following procedure applies to all of the cylinder
heads.
3-23
1
2
3
4
5
6
7
8
9
10
- Quick Links:
- Replacing the Engine Oil
Hide quick links:
Advertisement
Table of Contents
