Table of Contents
Advertisement
ELECTRICAL COMPONENTS
2
1
a
1
Coil resistance:
8.8–11.9 k
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the TCI unit.
b. Connect the digital circuit tester () to the terminal.
Model 88 Multimeter with tachometer:
YU-A1927
• Positive tester probe
High tension cord "1"
• Negative tester probe
Body ground "2"
c. Measure the coil resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
CHECKING THE IGNITION SPARK GAP
The following procedure applies to all of the TCI units.
1.
Check:
• Ignition spark gap
Out of specification Perform the ignition system
troubleshooting, starting with step 4.
(Refer to "IGNITION SYSTEM" on page 6-1)
Minimum ignition spark gap:
6.0 mm (0.236 in)
TIP
If the ignition spark gap is within specification, the ignition
system circuit is operating normally.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the spark plug cap "1" from the spark
plug.
b. Connect the ignition checker "2" as shown.
2
Ignition checker:
90890-06754
c. Turn the main switch to "START".
d. Measure the ignition spark gap "a".
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5-6
1
2
3
4
5
6
7
8
9
10
- Quick Links:
- Replacing the Engine Oil
Hide quick links:
Advertisement
Table of Contents
