Configuring Au-3 — Vc-3 — E3 - Cisco ASR 900 Series Configuration Manual
Interface module configuration
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (152 pages)
Table of Contents
Advertisement
Configuring AU-3 — VC-3 — E3
Configuring AU-3 — VC-3 — E3
To configure AU-3 — VC-3 — E3:
enable
configure terminal
controller sdh 0/5/0
rate stm4
au-3 1
mode e3
cem-group 100 unframed
end
Configuring Modes under AU-3 Mapping
This section describes the configuration of modes under AU-3 mapping.
Configuring Mode VC-1x
To configure mode VC-1x:
enable
configure terminal
controller sdh 0/5/0
rate stm4
au-3 1
mode VC1x
tug-2 1 payload VC11
tug-2 2 payload VC11
tug-2 3 payload VC11
tug-2 4 payload VC11
tug-2 5 payload VC11
tug-2 6 payload VC11
tug-2 7 payload VC11
end
end
Configuring AU-3 — TUG-2 — VC-11 — VC
To configure AU-3 — TUG-2 — VC-11 — VC:
configure terminal
controller MediaType 0/5/0
mode sdh
controller sdh 0/5/0
rate stm4
au-3 1
mode vc1x
tug-2 1 payload vc11
vc 1 cem-group 10 cep
end
Configuring AU-3 — TUG-2 — VC-12 — VC
To configure AU-3 — TUG-2 — VC-12 — VC:
configure terminal
controller MediaType 0/5/0
mode sdh
controller sdh 0/5/0
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
84
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
Advertisement
Table of Contents
