Prerequisites For Configuring Sonet; Configuring Mediatype Controller; Configuring Sonet Ports; Managing And Monitoring Sonet Line - Cisco ASR 900 Series Configuration Manual
Interface module configuration
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (152 pages)
Table of Contents
Advertisement
Prerequisites for Configuring SONET
Prerequisites for Configuring SONET
You must select the MediaType controller to configure and enter the controller configuration mode.
You must configure the controller as a SONET port.
Configuring MediaType Controller
To configure MediaType Controller, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
end
Configuring SONET Ports
To configure SONET ports, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
rate OC12
end
The above example shows how to configure SONET ports in OC-12 mode.
Managing and Monitoring SONET Line
This section describes how to manage and monitor SONET.
Configuring Line and Section Overhead
To configure line and section overhead, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
overhead s1s0 2
overhead j0 tx length 1-byte
end
To restore the system to its default condition, use the no form of the command.
Note
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
36
Configuring SONET
Advertisement
Table of Contents
