Configuring Line And Section Threshold; Configuring Line Loopback; Configuring Ais Shut; Configuring Shut - Cisco ASR 900 Series Configuration Manual
Interface module configuration
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (152 pages)
Table of Contents
Advertisement
Configuring SONET
Configuring Line and Section Threshold
To configure line and section threshold, use the following commands:
enable
configure terminal
controller sonet 0/5/0
threshold b2-tca 3
end
To restore the system to its default condition, use the no form of the command.
Note
enable
configure terminal
controller sonet 0/5/0
threshold b2-tca 3
end
To restore the system to its default condition, use the no form of the command.
Note
Configuring Line Loopback
To configure loopback, use the following commands:
enable
configure terminal
controller sonet 0/5/0
loopback local
end
To restore the system to its default condition, use the no form of the command.
Note
Configuring AIS Shut
To configure AIS-Shut, use the following commands:
enable
configure terminal
controller sonet 0/5/0
ais-shut
end
The no ais-shut command will not send AIS.
Note
Configuring Shut
To configure Shut, use the following commands:
enable
configure terminal
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Managing and Monitoring SONET Line
ASR 900 Series)
37
Advertisement
Table of Contents
