Configuring Mr-Aps On A Pos Interface - Cisco ASR 900 Series Configuration Manual
Time division multiplexing configuration; cisco ios xe fuji 16.7.x
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Configuring MR-APS on a POS interface
Configuring MR-APS on a POS interface
The following section shows how to configure the MR-APS integration on a POS interface on the working
node and protect node.
Configuring working node for POS MR-APS
To configure MR-APS working node for POS interface, complete the following steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. exit
4. redundancy
5. interchassis group group-id
6. member ip ip-address
7. monitor peer bfd
8. exit
9. controller SONET slot/bay/port
10. framing [SDH | SONET]
11. clock source internal
12. sts-1 1-3POS
13. exit
14. controller SONET slot/bay/port
15. Shutdown
16. aps group group_id
17. aps working aps-group-number
18. aps interchassis group group-id
19. no shut
20. exit
21. interface POS slot/bay/port
22. ip address ip-address
23. encapsulation ppp
24. end
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
84
Configuring Multi Router Automatic Protection Switching
Advertisement
Chapters
Table of Contents
