Configuring A Clear-Channel Atm Pseudowire - Cisco ASR 900 Series Configuration Manual
Time division multiplexing configuration; cisco ios xe fuji 16.7.x
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Configuring a Clear-Channel ATM Pseudowire
Command or Action
Step 5
exit
Example:
Router(config-controller)# exit
Step 6
interface cem slot/subslot
Example:
Router(config)#
Example:
Router(config-if-cem)#
Example:
Step 7
xconnect ip_address encapsulation mpls
Example:
Router(config-if)# xconnect 10.10.2.204
encapsulation mpls
Step 8
exit
Example:
Router(config-if-cem)# exit
Step 9
exit
Example:
Router(config)# exit
Configuring a Clear-Channel ATM Pseudowire
To configure the T1 interface module for clear-channel ATM, follow these steps:
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
24
interface CEM0/5
cem 5
Purpose
Exits controller configuration.
Defines a CEM channel.
Binds an attachment circuit to the CEM interface to create
a pseudowire. This example creates a pseudowire by
binding the CEM circuit 304 to the remote peer
10.10.2.204.
Exits the CEM interface.
Exits configuration mode.
Configuring Pseudowire
Advertisement
Chapters
Table of Contents
