Configuring A Protect Interface - Cisco ASR 900 Series Configuration Manual
Time division multiplexing configuration; cisco ios xe fuji 16.7.x
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Configuring a Protect Interface
Command or Action
Step 3
aps working circuit-number
Example:
Router(config-if)# aps working 1
Step 4
end
Example:
Router(config-if)# end
Configuring a Protect Interface
To configure a protect interface, use the following commands beginning in global configuration mode.
Before You Begin
To configure the controller in SDH mode, see
SUMMARY STEPS
1. controller sonet slot / port-adapter / port
2. aps group group-number acr
3. aps protect circuit-number ip-address
4. end
DETAILED STEPS
Command or Action
Step 1
controller sonet slot / port-adapter / port
Example:
Router(config)# controller sonet 0/0/0
Step 2
aps group group-number acr
Example:
Router(config-if)# aps group acr 2
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
60
Automatic Protection Switching Configuration
Purpose
Configures this interface as a working interface. 1 is the
only supported circuit-number value.
Exits configuration mode.
Configuring Optical Interface
Purpose
Returns to controller configuration mode.
(Optional) Allows more than one protect/working interface
group to be supported on a router.
Modules.
Advertisement
Chapters
Table of Contents
