Configuring An Atm Over Mpls Pseudowire - Cisco ASR 900 Series Configuration Manual
Time division multiplexing configuration; cisco ios xe fuji 16.7.x
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Configuring an ATM over MPLS Pseudowire
Command or Action
Step 7
end
Example:
Router(config-if)# end
Configuring an ATM over MPLS Pseudowire
ATM over MPLS pseudowires allow you to encapsulate and transport ATM traffic across an MPLS network.
This service allows you to deliver ATM services over an existing MPLS network.
The following sections describe how to configure transportation of service using ATM over MPLS:
•
•
•
Configuring the Controller
SUMMARY STEPS
1. enable
2. configure terminal
3. card type {e1} slot/subslot
4. controller {e1} slot/subslot
5. clock source {internal | line}
6. ima-group group-number scrambling-payload
7. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
26
Configuring the Controller, on page 26
Configuring an IMA Interface, on page 27
Configuring the ATM over MPLS Pseudowire Interface, on page 29
Purpose
Exits configuration mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Configuring Pseudowire
Advertisement
Chapters
Table of Contents
