Verifying Cas Configuration; Configuration Examples For Cas - Cisco ASR 900 Series Configuration Manual
Time division multiplexing configuration; cisco ios xe fuji 16.7.x
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Verifying CAS Configuration
What to Do Next
You can configure CEM interface and parameters such as xconnect.
Verifying CAS Configuration
Use the show cem circuit cem-group-id command to display CEM statistics for the configured CEM circuits.
If xconnect is configured under the circuit, the command output also includes information about the attached
circuit.
Following is a sample output of the show cem circuit command to display the detailed information about
CEM circuits configured on the router:
Router# show cem circuit 0
CEM0/3/0, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 8 (In use: 0)
Payload Size: 32
Framing: Framed (DS0 channels: 1)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
The show cem circuit command displays No CAS for the Signaling field. The No CAS is displayed since
Note
CAS is not enabled at the CEM interface level. The CAS is enabled for the entire port and you cannot
enable or disable CAS at the CEM level. To view the CAS configuration, use the show running-config
command.
Configuration Examples for CAS
The following example shows how to configure CAS on a CEM interface on the router:
Router# configure terminal
Router(config)# controller E1 0/4/2
Router(config-controller)# cas
Router(config-controller)# clock source internal
Router(config-controller)# cem-group 0 timeslots 1
Router(config-controller)# exit
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
16
5001
Dropped:
5001
Dropped:
0
Output Errors:
0
Pkts Reordered:
0
JitterBuf Underrun:
0
Severly Errored Sec: 0
Failure Counts:
0
JitterBuf Overrun:
Configuring Pseudowire
0
0
0
0
0
0
0
Advertisement
Chapters
Table of Contents
