Configuring L2Tp - Cisco RV215W Administration Manual
Wireless-n vpn firewall
Hide thumbs
Also See for RV215W:
- Administration manual (149 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Networking
STEP 4
STEP 1
STEP 2
STEP 3
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 2—Cisco Confidential
Connect on Demand
Keep alive
Authentication Type
Click Save.
Configuring L2TP
To configure the L2TP settings:
Choose Networking > WAN.
From the Internet Connection Type drop-down menu, choose L2TP.
Enter this information:
Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle—
that is, no traffic is flowing—the connection is
closed. If you click Connect on Demand, enter the
number of minutes after which the connection
shuts off in the Max Idle Time field.
When you select this option, the Internet
connection is always on. In the redial period field,
enter the number of seconds after which the
attempts to reconnect if it is disconnected.
Choose the authentication type:
Auto-negotiation—The server sends a
configuration request specifying the security
algorithm set on it. Then, the sends back
authentication credentials with the security type
sent earlier by the server.
PAP—The uses the Password Authentication
Protocol (PAP) to connect to the ISP.
CHAP—The uses the Challenge Handshake
Authentication Protocol (CHAP) when connecting
with the ISP.
MS-CHAP or MS-CHAPv2—The uses Microsoft
Challenge Handshake Authentication Protocol
when connecting with the ISP.
2
19
Advertisement
Table of Contents
