Configuring Static Ip; Configuring Dhcp - Cisco RV215W Administration Manual
Wireless-n vpn firewall
Hide thumbs
Also See for RV215W:
- Administration manual (149 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Configuring Networking
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Draft Version 2—Cisco Confidential
Configuring the Wired WAN Connections
Configuring WAN properties for an IPv4 network differs depending on which type
of Internet connection you have.
Configuring DHCP (Automatic Configuration)
If your Internet Service Provider (ISP) uses the Dynamic Host Control Protocol
(DHCP) to assign you an IP address, you receive a IP address that is dynamically
generated each time you log in.
To configure the DHCP WAN settings:
Choose Networking > WAN.
From the Internet Connection Type drop-down menu, select Automatic
Configuration - DHCP.
Click Save.
Configuring Static IP
If your ISP assigned you a permanent IP address, perform the following steps to
configure your WAN settings:
Choose Networking > WAN.
From the Internet Connection Type drop-down menu, choose Static IP.
Enter this information:
Internet IP Address
Subnet mask
IP address of the firewall WAN port.
Subnet mask of the firewall WAN port.
2
16
Advertisement
Table of Contents
