Connecting The Console And Auxiliary Port Cables - Cisco ASR 1004 Overview And Installation

Hide thumbs Also See for ASR 1004:

Table of Contents

Connecting the Console and Auxiliary Port Cables

http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/

pa-pos-oc3_install_config/paposoc3.html

Connecting the Console and Auxiliary Port Cables

The Cisco ASR 1004 Router has a DCE-mode console port for connecting a console terminal and an auxiliary

port for additional connections to your chassis. The auxiliary port can also be used for diagnostics. The

following shows the CON and AUX ports on the Cisco ASR 1000 Series route processor.

The Cisco ASR 1004 Router uses RJ-45 ports for both the auxiliary port and the console port. Both the console

and the auxiliary ports are asynchronous serial ports; any devices connected to these ports must be capable

of asynchronous transmission.

Note

A connection will not be established when setting up an out-of-band connection or modem connection in

the auxiliary port and the console port.

For console and auxiliary port pinouts for the RJ-45 connector, see

section on page A-5

SUMMARY STEPS

1. Before connecting a terminal to the console port, configure the terminal to match the chassis console port

as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).

2. After you establish normal router operation, you can disconnect the terminal.

Cisco ASR 1000 Series Router Hardware Installation Guide

Console port - CON

. Both ports are configured as asynchronous serial ports.

Cisco ASR 1004 Router Overview and Installation

Auxiliary port - AUX

"Cisco ASR 1004 Router Specifications"

Table of Contents