Cisco ONS 15600 Reference Manual page 90
Hide thumbs
Also See for ONS 15600:
- Reference manual (376 pages) ,
- Installation instructions manual (14 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
4.5.1 Node View
Table 4-2
Card Color
Orange
Red
Port color in both card and node view indicates the port service state.
their service states. For more information about port service states, see
Service States."
Table 4-3
Port Color
Blue
Blue
Gray
Green
Violet
Cisco ONS 15600 Reference Manual, R6.0
4-8
Node View Card Colors (continued)
Status
Slot is provisioned; a major alarm condition exists.
Slot is provisioned; a critical alarm exists.
Node View Card Port Colors and Service States
Service State
Description
OOS-MA,LPBK
(Out-of-Service and Management, Loopback) Port is in a
loopback state. On the card in node view, a line between
ports indicates that the port is in terminal or facility
loopback (see
and alarm reporting is suppressed. Raised fault conditions,
whether or not their alarms are reported, can be retrieved
on the CTC Conditions tab or by using the TL1
RTRV-COND command.
OOS-MA,MT
(Out-of-Service and Management, Maintenance) Port is
out-of-service for maintenance. Traffic is carried and
loopbacks are allowed. Alarm reporting is suppressed.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. Use OOS-MA,MT
for testing or to suppress alarms temporarily. Change the
state to IS-NR, OOS-MA,DSBLD, or OOS-AU,AINS
when testing is complete.
OOS-MA,DSBLD
(Out-of-Service and Management, Disabled) The port is
out-of-service and unable to carry traffic. Loopbacks are
not allowed in this service state.
IS-NR
(In-Service and Normal) The port is fully operational and
performing as provisioned. The port transmits a signal and
displays alarms; loopbacks are not allowed.
OOS-AU,AINS
(Out-of-Service and Autonomous, Automatic In-Service)
The port is out-of-service, but traffic is carried. Alarm
reporting is suppressed. The node monitors the ports for an
error-free signal. After an error-free signal is detected, the
port stays in OOS-AU,AINS state for the duration of the
soak period. After the soak period ends, the port service
state changes to IS-NR.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. The AINS port
will automatically transition to IS-NR when a signal is
received for the length of time provisioned in the soak
field.
Chapter 4
Cisco Transport Controller Operation
Table 4-3
lists the port colors and
Appendix B, "Administrative and
Figure 4-4
and
Figure
4-5). Traffic is carried
Advertisement
Chapters
Table of Contents
