Verifying The Initial Configuration - Cisco IR829 Hardware Installation Manual
Integrated services router
Hide thumbs
Also See for IR829:
- Product manual (16 pages) ,
- Hardware installation manual (56 pages) ,
- Hardware installation manual (69 pages)
Table of Contents
Advertisement
Chapter 4
Initial Configuration
Async0
Async1
GigabitEthernet2
Cellular0
Cellular1
Choose one of the available interfaces for connecting the router to the management network.
Step 9
Enter interface name used to connect to the
management network from the above interface summary: GigabitEthernet0
Respond to the following prompts as appropriate for your network:
Step 10
Configuring interface GigabitEthernet0:
Configure IP on this interface? [yes]: yes
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface GigabitEthernet0
no shutdown
speed 100
duplex auto
ip address 172.16.2.3 255.255.0.0
!
Step 11
Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Verify the initial configuration. See the
Step 12
verification procedures.
unassigned
YES unset
unassigned
YES unset
unassigned
NO
unset
unassigned
NO
unset
unassigned
NO
unset
"Verifying the Initial Configuration" section on page 4-4
Cisco IR829 Integrated Services Router Hardware Installation Guide
Setup Command Facility
up
down
up
down
up
up
down
down
down
down
for
4-3
- Quick Links:
- Table of Contents
- Installation and Upgrade
Hide quick links:
Advertisement
Table of Contents
