hit counter script

Configuring Guest Os Interface On Cisco Ios - Cisco IR829 Hardware Installation Manual

Integrated services router
Hide thumbs Also See for IR829:
Table of Contents

Advertisement

Chapter 5
Guest Operating System (Guest OS) Installation and Configuration

Configuring Guest OS Interface on Cisco IOS

The Guest OS Ethernet port (eth0) connects to GigabitEthernet 5 on Cisco IOS. To configure the
GigabitEthernet 5 interface with the default gateway address of the DHCP pool, enter the following
commands:
Note
IPv6 must always be enabled on GigabitEthernet 5.
Command
interface GigabitEthernet 5
ipv6 enable
ipv6 address 2001:DB8:FFFF:0000:0000:0000:0001
ipv4 enable
ipv4 address 9.1.2.1 255.255.255.0
no shutdown
There exists a condition where the IR829 could display slow performance if the guest OS is consuming
Note
too many CPU resources.
By default, Guest OS gets 50% of one of the cores of the CPU. The following command allows you to
change the percentage of CPU allocation to VDS out of 100. The rest will go to Guest OS. In the situation
where you don't use the Guest OS, the CPU can be allocated 90% to VDS.
For Example:
IR800>en
IR800#config t
Enter configuration commands, one per line.
IR800(config)#iox hypervisor ?
sched-policy
IR800(config)#iox hypervisor sched-policy ?
10
20
30
40
50
60
70
80
90
IR800(config)#iox hypervisor sched-policy 90
percentage of CPU ticks to VDS
VDS
10%
Guest OS 90%
VDS
20%
Guest OS 80%
VDS
30%
Guest OS 70%
VDS
40%
Guest OS 60%
VDS
50%
Guest OS 50%
VDS
60%
Guest OS 40%
VDS
70%
Guest OS 30%
VDS
80%
Guest OS 20%
VDS
90%
Guest OS 10%
Purpose
Set the internal virtual interface that
connects to the Linux Guest OS.
Enables IPv6.
Sets the IPv6 address.
Enables IPv4.
Sets the IPv4 address.
End with CNTL/Z.
Cisco IR829 Integrated Services Router Hardware Installation Guide
Configuring Cisco IOS
5-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents