Table of Contents
Advertisement
Appendix
15
Problem
OTHER
• TV-Guide data cannot be obtained.
• An external device connected to the
USB port does not operate.
• Photo data stored in a digital still
camera cannot be read through USB
interface.
• Panel sounds / noises
• Screen displays uneven brightness on
the sides.
If the following error codes appear on the screen, check the corresponding items in the table.
Code
Message
SD04 and
Powering off. Internal temperature too high.
SD11
Check temperature around PDP .
SD05
(PRO-1150HD)
Internal protection circuit turns power off.
Is there a short in speaker cable?
(PRO-950HD)
Internal protection circuit turns power off.
106
En
Possible Solution
• If TV-Guide data cannot be obtained with ANT.A selected for cable connection, select ANT.B for over the air.
In addition, try the TV-Guide setup again by performing the following procedure (see page 33):
- Select "Antenna" for "Select service(s)" on Screen 3.
- Select "ANT B IN" on Screen 4.
• Check if the device is connectable to the display. (See page 73.)
• Re-insert the USB cable. (See page 73.)
• For connection, use a USB cable shorter than 5 m. (See page 73.)
• Check if the USB cable is properly connected. (See page 73.)
• First turn the power off and then turn it on again in order to check if the external device works correctly.
• Check if the external device works correctly after the USB device was restarted.
• Check if the digital still camera is in the viewing mode.
• Refer to the instruction manual for the digital still camera.
• Check if the device is connectable to the display. (See page 73.)
• Check if the digital still camera is turned on.
• Panel generated sounds, examples: Fan motor noise, Electrical Circuit Humming / Glass Panel buzzing are
normal operation of a phosphor-based matrix display.
• Display content that completely fills the screen until unevenness is minimized. Some signals may require to
change the AV mode setting. (See page 62.)
Check
Check if the ambient temperature of the plasma display is high.
Check the speaker cable connections between the plasma display and the speakers.
Contact the nearest Pioneer Authorized Independent Service Company, or the
Customer Support Division. (See back cover.)
Hide quick links:
Advertisement
Table of Contents
