Audio Configuration; Xconfiguration Audio Defaultvolume; Xconfiguration Audio Microphones Mute Enabled; Xconfiguration Audio Microphonereinforcement Input Microphone [1..8] Mode - Cisco TelePresence SX80 Reference Manual
Application programming interface (api)
Hide thumbs
Also See for TelePresence SX80:
- Reference manual (231 pages) ,
- Administrator's manual (183 pages) ,
- Installation manual (24 pages)
Table of Contents
Advertisement
Cisco TelePresence SX80
Introduction
Audio configuration
xConfiguration Audio DefaultVolume
Define the default volume for the speakers. The volume is set to this value when you switch
on or restart the video system. Use the Touch controller to change the volume while the video
system is running. You may also use API commands (xCommand Audio Volume) to change the
volume while the video system is running, and to reset to default value.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
USAGE:
xConfiguration Audio DefaultVolume:
where
: Integer (0..100)
DefaultVolume
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB. If set to 0 the audio is switched off.
xConfiguration Audio Microphones Mute Enabled
Define the microphone mute behaviour on the video system.
Requires user role: ADMIN, INTEGRATOR
Default value: True
USAGE:
xConfiguration Audio Microphones Mute Enabled:
where
: True/InCallOnly
Enabled
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is
not possible to mute the microphone. This is useful when an external telephone service/
audio system is connected via the codec and is to be available when the codec is not
in a call. When set to InCallOnly this will prevent the audio-system from being muted by
mistake.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API
xConfiguration
xConfiguration
DefaultVolume
Enabled
xCommand
xConfiguration Audio MicrophoneReinforcement Input Microphone [1..8] Mode
Set the microphone reinforcement mode individually on each microphone. The signals from all
microphones with Mode = On will be mixed and fed to the selected MicrophoneReinforcement
outputs. Also consult the Audio MicrophoneReinforcement Output Line Mode setting.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Audio MicrophoneReinforcement Input Microphone
where
: Off/On
Mode
On: The microphone signal will be fed to the selected MicrophoneReinforcement
outputs, as well as to the far end.
Off: The microphone signal will be sent only to the far end. It will not be fed to the
selected MicrophoneReinforcement outputs.
xConfiguration Audio MicrophoneReinforcement Output Line [1..4] Mode
Set the microphone reinforcement mode individually on each line output. If Mode = On, the line
output will add the microphone reinforcement mix to its ordinary output signal. Also consult the
Audio MicrophoneReinforcement Input Microphone Mode setting.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Audio MicrophoneReinforcement Output Line
where
: Off/On
Mode
On: This output will deliver far end audio, local presentation audio and the microphone
reinforcement mix.
Off: This output will deliver far end audio and local presentation audio.
34
API Reference Guide
xStatus
Appendices
n
Mode:
n
Mode:
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Mode
- Quick Links:
- Commands
- About Disconnect Cause Types
Hide quick links:
Advertisement
Chapters
Table of Contents
