Table of Contents
Advertisement
Configuring IP Multicast Routing
This example shows a portion of an IP multicast boundary configuration that denies Auto-RP
information:
Switch(config)# access-list 1 deny 224.0.1.39
Switch(config)# access-list 1 deny 224.0.1.40
Switch(config)# access-list 1 permit all
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip multicast boundary 1
Configuring Candidate BSRs
You can configure one or more candidate BSRs. The devices serving as candidate BSRs should have
good connectivity to other devices and be in the backbone portion of the network.
Beginning in privileged EXEC mode, follow these steps to configure your switch as a candidate BSR.
This procedure is optional.
Command
Step 1
configure terminal
Step 2
ip pim bsr-candidate interface-id
hash-mask-length [priority]
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
To remove this device as a candidate BSR, use the no ip pim bsr-candidate global configuration
command.
This example shows how to configure a candidate BSR, which uses the IP address 172.21.24.18 on a
port as the advertised BSR address, uses 30 bits as the hash-mask-length, and has a priority of 10.
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip address 172.21.24.18 255.255.255.0
Switch(config-if)# ip pim sparse-dense-mode
Switch(config-if)# ip pim bsr-candidate gigabitethernet1/0/2 30 10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
44-32
Purpose
Enter global configuration mode.
Configure your switch to be a candidate BSR.
•
For interface-id, enter the interface on this switch from which the
BSR address is derived to make it a candidate. This interface must
be enabled with PIM. Valid interfaces include physical ports, port
channels, and VLANs.
For hash-mask-length, specify the mask length (32 bits maximum)
•
that is to be ANDed with the group address before the hash function
is called. All groups with the same seed hash correspond to the same
RP. For example, if this value is 24, only the first 24 bits of the
group addresses matter.
(Optional) For priority, enter a number from 0 to 255. The BSR with
•
the larger priority is preferred. If the priority values are the same,
the device with the highest IP address is selected as the BSR. The
default is 0.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 44
Configuring IP Multicast Routing
OL-12247-04
Advertisement
Chapters
Table of Contents
Troubleshooting
