Cisco Nexus 5600 Series Configuration Manual page 230
Nx-os system management
Hide thumbs
Also See for Nexus 5600 Series:
- Hardware installation manual (100 pages) ,
- Reference (480 pages)
Table of Contents
Advertisement
Configuring an ERSPAN Destination Session
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
208
Command or Action
switchport mode [access | trunk]
Example:
switch(config-if)# switchport mode
trunk
switchport monitor
Example:
switch(config-if)# switchport monitor
Repeat Steps 2 to 5 to configure monitoring
on additional ERSPAN destinations.
no monitor session {session-number | all}
Example:
switch(config-if)# no monitor session
3
monitor session {session-number | all} type
erspan-destination
Example:
switch(config-if)# monitor session 3
type erspan-destination
switch(config-erspan-dst)#
description description
Example:
switch(config-erspan-dst)# description
erspan_dst_session_3
source ip ip-address
Example:
switch(config-erspan-dst)# source ip
10.1.1.1
destination {[interface [type
slot/port[-port], [type slot/port [port]]]
[port-channel channel-number]]}
Example:
switch(config-erspan-dst)# destination
interface ethernet 2/5
Purpose
Configures the following switchport modes for the
selected slot and port or range of ports:
• access
• trunk
Configures the switch interface in monitor mode.
To configure an interface to be an ERSPAN or
SPAN destination (using the destination interface
ethernet interface command), it must first be
configured in monitor mode.
—
Clears the configuration of the specified ERSPAN
session. The new session configuration is added to
the existing session configuration.
Configures an ERSPAN destination session.
Configures a description for the session. By default,
no description is defined. The description can be
up to 32 alphanumeric characters.
Configures the source IP address in the ERSPAN
session. Only one source IP address is supported
per ERSPAN destination session.
This IP address must match the destination IP
address configured in the corresponding ERSPAN
source session.
Configures a destination for copied source packets.
You can configure only interfaces as a destination.
You can configure destination ports as
Note
trunk ports.
Configuring ERSPAN
OL-31641-01
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
