Synchronizing Configurations After A Switch Reboot; Switch Profile Configuration Show Commands - Cisco Nexus 5600 Series Configuration Manual
Nx-os system management
Hide thumbs
Also See for Nexus 5600 Series:
- Hardware installation manual (100 pages) ,
- Reference (480 pages)
Table of Contents
Advertisement
Configuring Switch Profiles
Switch-Profile started, Profile ID is 1
switch(config-sync-sp)# show switch-profile sp buffer
----------------------------------------------------------
Seq-no
----------------------------------------------------------
1
1.1
2
3
3.1
3.2
switch(config-sync-sp)# buffer-move 3 1
switch(config-sync-sp)# show switch-profile sp buffer
----------------------------------------------------------
Seq-no
----------------------------------------------------------
1
1.1
1.2
2
2.1
3
switch(config-sync-sp)#
Synchronizing Configurations After a Switch Reboot
If a Cisco Nexus Series switch reboots while a new configuration is being committed on a peer switch using
a switch profile, complete the following steps to synchronize the peer switches after reload:
Procedure
Step 1
Reapply configurations that were changed on the peer switch during the reboot.
Step 2
Enter the commit command.
Step 3
Verify that the configuration is applied correctly and both peers are back synchronized.
Switch Profile Configuration show Commands
The following show commands display information about the switch profile.
Command
show switch-profile name
show switch-profile name buffer
show switch-profile name peer IP-address
show switch-profile name session-history
show switch-profile name status
OL-31641-01
Command
vlan 101
ip igmp snooping querier 10.101.1.1
mac address-table static 0000.0000.0001 vlan 101 drop
interface Ethernet1/2
switchport mode trunk
switchport trunk allowed vlan 101
Command
interface Ethernet1/2
switchport mode trunk
switchport trunk allowed vlan 101
vlan 101
ip igmp snooping querier 10.101.1.1
mac address-table static 0000.0000.0001 vlan 101 drop
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
Synchronizing Configurations After a Switch Reboot
Purpose
Displays the commands in a switch profile.
Displays the uncommitted commands in a switch profile, the
commands that were moved, and the commands that were
deleted.
Displays the synchronization status for a peer switch.
Displays the status of the last 20 switch profile sessions.
Displays the configuration synchronization status of a peer
switch.
23
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
