Importing Configurations In A Vpc Topology - Cisco Nexus 5600 Series Configuration Manual
Nx-os system management
Hide thumbs
Also See for Nexus 5600 Series:
- Hardware installation manual (100 pages) ,
- Reference (480 pages)
Table of Contents
Advertisement
Configuring Switch Profiles
switch(config-sync-sp-import)#
switch(config-sync-sp-import)# show switch-profile buffer
switch-profile
----------------------------------------------------------
Seq-no
----------------------------------------------------------
3
4
4.1
5
6
6.1
7
switch(config-sync-sp-import)#
Importing Configurations in a vPC Topology
You can import configurations in a two-switch vPC topology.
Note
For specific information about the following steps, see the appropriate sections in this chapter.
1 Configure the switch profile with the same name on both switches.
2 Import the configurations to both switches independently.
Ensure that the configuration moved to the switch profile on both switches is identical; otherwise, a
Note
merge-check failure might occur.
3 Configure the switches by entering the sync-peer destination command.
4 Verify that the switch profiles are the same by entering the appropriate show commands.
Verifying Commands in a Switch Profile
You can verify the commands that are included in a switch profile by entering the verify command in switch
profile mode.
Procedure
Step 1
OL-31641-01
: sp
Command
vlan 100-299
vlan 300
state suspend
vlan 301-345
interface port-channel100
spanning-tree port type network
interface port-channel105
Command or Action
config sync
Example:
switch# config sync
switch(config-sync)#
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
Importing Configurations in a vPC Topology
Purpose
Enters configuration synchronization mode.
19
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
