Configuring Ip Source Guard For Static Hosts On A Layer 2 Access Port - Cisco Catalyst 2960 series Configuration Manual
Consolidated platform configuration guide, ios release 15.2(4)e
Hide thumbs
Also See for Catalyst 2960 series:
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages) ,
- Configuration manual (120 pages)
Table of Contents
Advertisement
Command or Action
Step 5
exit
Example:
Switch(config-if)# exit
Step 6
ip source binding mac-address vlan vlan-id ip-address
interface interface-id
Example:
Switch(config)# ip source binding 0100.0230.0002
vlan 11 10.0.0.4 interface gigabitethernet1/0/1
Step 7
end
Example:
Switch(config)# end
Step 8
show running-config
Example:
Switch# show running-config
Step 9
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Configuring IP Source Guard for Static Hosts on a Layer 2 Access Port
You must configure the ip device tracking maximum limit-number interface configuration command globally
for IPSG for static hosts to work. If you only configure this command on a port without enabling IP device
tracking globally or by setting an IP device tracking maximum on that interface, IPSG with static hosts rejects
all the IP traffic from that interface.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure IP Source Guard
Purpose
Returns to global configuration mode.
Adds a static IP source binding.
Enter this command for each static binding.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
1295
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
