Table of Contents
Advertisement
Installing the Cisco NCS 2006 Door and Other Modules
• 2 BITS-OUT connections (2 subminiature version B [SMB] connectors for ETSI and 4 wire-wrap pins
• 10 MHz IN and OUT and PPS IN and OUT (hardware-ready)
• 2 BITS-IN connections (2 SMB connectors for ETSI and 4 wire-wrap pins for ANSI)
• 6 multishelf connections
• 1 element management system (EMS) connection
• 1 craft terminal connection
• 1 time-of-day (ToD) connection (hardware-ready)
• 2 VoIP or 2 user data channel (UDC) connections, or one each of VoIP and UDC connections
• 1 SCSI with 26 poles for TNC relay contact, including alarm cut-off (ACO) signal and digital I/O (D-I/O)
• 1 SCSI with 26 poles for digital I/O signals (on the right-side connector)
NCS 2006 ECU60-S
ECU60-S is a new type of ECU-S introduced for the NCS 2006 when the shelf is powered at –60 VDC nominal
input voltage. The ECU60-S module available for the NCS 2006 shelf is NCS2006-ECU60-S=.
The following figure shows the NCS 2006 ECU60-S connectors.
Figure 165: Connectors on the NCS 2006 ECU60-S Faceplate
1
2
3
4
5
6
◦
4 USB 2.0 on the left of the faceplate are detected as A1, A2, A3, A4.
◦ 4 USB 2.0 ports on the right of the faceplate are detected as B1, B2, B3, B4. In Release 10.1, 10.3,
and 10.5, these ports are detected as A5, A6, B1, B2 respectively.
for ANSI)
signals (on the left-side connector)
USB 2.0 ports (Ports 1 through 4 and ports 7 through
10)
USB 3.0 ports (Ports 5 and 11)
VOIP/UDC ports (RJ-45 port)
EMS port (RJ-45 port)
MSM ports
Craft terminal connection
Cisco NCS 2000 Series Hardware Installation Guide
NCS 2006 ECU60-S
273
- Quick Links:
- Cisco Ncs 2006 Shelf
- Ncs 2006
Hide quick links:
Advertisement
Chapters
Table of Contents
