Table of Contents
Advertisement
Hot-Swapping an Interface Module
Table 7: Supported Hot Swapping Combinations
Interface Modules
8-port Gigabit Ethernet SFP Interface Module (8X1GE)
8-port Gigabit Ethernet RJ45 (Copper) Interface Module (8X1GE)
SFP Combo IM—8-port Gigabit Ethernet (8X1GE) +
1-port 10 Gigabit Ethernet (1X10GE)
Copper Combo IM—8-port Gigabit Ethernet (8X1GE)
+ 1-port 10 Gigabit Ethernet Interface Module(1X10GE
1-port 10 Gigabit Ethernet XFP Interface Module (1X10GE)
2-port 10 Gigabit Ethernet Interface Module(2X10GE)
8-port 10 Gigabit Ethernet Interface Module (8X10GE)
1-port 100 Gigabit Ethernet Interface Module (1X100GE)
2-port 40 Gigabit Ethernet QSFP Interface Module (2X40GE)
16 x T1/E1 Interface Module
32 x T1/E1 Interface Module
8 X T1/E1 Interface Module
4-Port OC3/STM-1 (OC-3) or 1-Port OC12/STM-4 (OC-12)
Interface Module
Table 8: Supported Hot Swapping Combinations
Interface Modules
1-Port OC-192 or 8-Port Low Rate CEM Interface Module
48 x T1/E1 Interface Module
48 X T3/E3 Interface Module
When you remove or insert a redundant module while the router is powered on and running, the router does
the following:
1 Determines if there is sufficient power for the module.
2 Scans the backplane for configuration changes.
Cisco ASR 907 Router Hardware Installation Guide
74
A900-RSP3C-400-W/Cisco IOS Release 3.16 and later
Swapping allowed on all Ethernet interface modules
No support
4-Port OC3/STM-1 (OC-3) or 1-Port OC12/STM-4 (OC-12)
Interface Module
A900-RSP3C-400-W/Cisco IOS Release 3.18.1 SP
No support
Installing the Cisco ASR 907 Router
Advertisement
Table of Contents
