Table of Contents
Advertisement
Installing Dust Caps
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Follow these steps to remove and replace the AC power supply:
Step 1
Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord when it is still
connected to the power supply.
Step 2
Remove the power cord from the power connection on the power supply. Do not touch the metal prongs embedded in
the power supply.
Step 3
Loosen the captive installation screws.
Step 4
Grasp the AC power supply with one hand, and slide it part of the way out of the chassis. Place your other hand underneath
the power supply, and slide it completely out of the chassis.
Step 5
If the power supply bay is to remain empty, install a blank filler plate (Cisco part number A900-PWR-BLANK) over
the opening, and secure it with the captive installation screws.
Installing Dust Caps
The following list provides the product IDs (PIDs) for the dust caps that are available for each port type:
• RJ-45—A900-DCAP-RJ45-S= (24 dust caps per package) or A900-DCAP-RJ45-L= (240 caps per
• SFP—A900-DCAP-SFP-S= (24 caps per package) or A900-DCAP-SFP-L= (240 caps per package)
• USB—A900-DCAP-USB-S= (12 dust caps per package) or A900-DCAP-USB-L= (120 dust caps per
• XFP/QSFP—A900-DCAP-XFP-S= (12 dust caps per package) or A900-DCAP-XFP-L= (120 dust caps
To install the dust cap:
1 Hold the dust cap by its handle.
2 Insert the dust cap in to the appropriate unused ports (RJ-45, SFP, USB, or XFP/QSFP) on the chassis
front panel.
Connecting the Cisco ASR 907 Router to the Network
Note
When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling
sufficient to allow for fan tray removal.
Cisco ASR 907 Router Hardware Installation Guide
90
package)
package)
per package)
Installing the Cisco ASR 907 Router
Advertisement
Table of Contents
